Browse all practice questions for the Michelin ECT Full Course Practice Exam. Search by topic, open any question and review its full explanation, then test yourself in the practice quiz.

Michelin ECT Full Course Practice Exam course image
More practice questions

These questions are part of the practice quiz. Start practicing

  • How does rotor speed interact with the magnetic field in an induction motor?
  • Which item is typically listed on a motor nameplate?
  • Which equation correctly defines AC motor efficiency?
  • On an AC motor nameplate, rated load current in amps is at
  • Which standards govern electrical diagram symbols?
  • Which of the following does NOT determine magnetic field strength?
  • What is used to provide an interface with machine logic in a photo cell?
  • If a coil is good it should read approximately ______ ohms for a 120v coil, and approximately _______ ohms for a 24v coil.
  • Which statement correctly identifies the problematic behavior of shielded capacitive proximity sensors in certain environments?
  • Percent slip at no-load is less than 1% while at full-load is usually between 3% and 5%. What does this indicate about the motor?
  • Stop buttons are which color?
  • What are the two classes of AC motors?
  • An overload current is typically one to six times the normal current. Which option correctly states this range?
  • What determines the strength of a magnetic field?
  • Which formula expresses frequency in terms of the time period T?
  • What do ORANGE or YELLOW wires signify?
  • Push buttons are considered light or heavy duty based on...
  • Which statement best defines short circuit current?
  • How do you reverse a three-phase motor?
  • Which item is listed as the first advantage of AC motors over DC motors?
  • How many watts are in one horsepower?
  • For AC motor codes, the higher the motor code indicates
  • What is the term for the difference between the on and off points of proximity sensors?
  • Which device opposes a change in current?
  • The function of the circuit breaker corresponds basically to that of
  • Start buttons are what color and type?
  • What is Overcurrent?
  • Power Factor (PF) is defined as cos(phi). Which option correctly states PF?
  • In an ambient-compensated circuit breaker, what happens when ambient temperature increases?
  • What are the forward voltage drops for Germanium and Silicon diodes, and which type is more commonly used?
  • What is Ohm's Law?
  • Capacitive proximity sensors are capable of detecting which surfaces?
  • Which photocell configuration detects the target by receiving light reflected from the target back into the sensor?
  • What do thermal cutouts in dual-element fuses allow for?
  • To detect targets with low dielectric constant, which proximity sensor variant is typically chosen?
  • What are the three types of Photocell configurations?
  • State Lenz's Law.
  • What is the stated purpose of the stator in AC motors?
  • What is interrupting capacity?
  • Which statement distinguishes Open Drip Proof (ODP) from Totally Enclosed Fan-Cooled (TEFC) motors?
  • Which proximity sensor type is commonly used to detect fluid levels through a tank?
  • What does the third digit in a motor frame size specify?
  • In a circuit with capacitors connected in parallel, the total capacitance does what?
  • Which statement best describes orange or yellow wires?
  • According to NEMA, what is motor 'design'?
  • Inductive Reactance Xl is the opposition to the flow of alternating current caused by the inductance of a circuit, measured in ohms. Which option correctly defines Xl?
  • What does the 'Duty' block mean on a motor nameplate?
  • The overload relay is used to protect motors in case of prolonged overload at what percentage of full-load current?
  • If inductive reactance X_L is calculated by X_L = 2 pi f L, what happens to X_L when frequency doubles?
  • This core of a contactor or relay is made of laminated steel in order to ___________________________
  • Reactive Power (Q) is given by V × I × sin(phi) and is measured in VARS. Which option represents Reactive Power?
  • Which statement defines the Voltage Rating of a fuse?
  • For a 445T motor, what is the shaft height?
  • In motor control, which device is used to switch power to the motor and is energized by the control circuit?
  • In a balanced three-phase system, which expressions correctly give real, reactive, and apparent power?
  • Reactive power is measured in which units?
  • Formula for the speed of the magnetic field in an induction motor is Ns = (60 × f) ÷ P. What does P represent?
  • Which statement best describes orange or yellow wires?
  • Real Power (P) in a circuit is calculated as V × I × cos(phi) and is measured in Watts. Which of the following expressions represents Real Power?
  • What is shaft horsepower?
  • Which of the following is a likely symptom when shielded capacitive sensors operate in dirty or damp conditions?
  • The impedance triangle is used to visualize which quantities together?
  • Which device is typically used to provide isolation between the control signal and the high-power motor circuit?
  • In IEC contactor life expectations, which two counts are commonly specified?
  • A magnetic circuit breaker trips when?
  • Which photocell configuration uses a separate reflector to bounce light back to the receiver?
  • Impedance Z is the vector sum of which two quantities?
  • In a TEFC motor, what best describes the enclosure's interaction with outside air?
  • What is the inherent problem with ultrasonic proximity sensors?
  • Henry is the unit of inductance. Which option correctly identifies the unit for inductance?
  • In a transformer, the coil which receives energy from the AC source is called the
  • In protective coordination, which statement describes the desired outcome?
  • What do WHITE wires with BLUE STRIPES signify?
  • What is the purpose of the stator in both classes of AC motors?
  • Which of the following is an advantage of a three-phase system compared with a single-phase system?
  • Which statement best describes the Interrupting Rating?
  • What is a Totally Enclosed Fan-Cooled (TEFC) motor?
  • When would you want to use a shielded capacitive sensor as opposed to an unshielded variant?
  • What are the positive and negative terminals of a diode called?
  • Which statement best defines overload current?
  • To reliably detect materials with very low dielectric constant, which sensor variant is appropriate?
  • What is resistance?
  • Start buttons are which color?
  • Which statement correctly defines the Continuous Current Rating?
  • Which sensor type is commonly used to sense through a tank wall for non-metallic contents?
  • Which organization is known for establishing safety standards in North America for electrical equipment?
  • Which sensing category uses a dark-operate output when no target is present?
  • Which statement about conductor sizing is accurate?
  • Is a motor rated for 460V safe to use on a 480V circuit?
  • Which aspects of an AC motor are determined by its frame size?
  • Where is ambient-compensated circuit breaker typically used?
  • A _________is always used in the control circuit.
  • A thermal-magnetic circuit breaker is characterized by which arrangement?
  • Which statement correctly identifies the most common lifecycle count for IEC contactors?
  • What is the correct expression for actual shaft speed Nr when considering slip?
  • What are the two main classes of INDUCTION motors?
  • Who is best swearing?
  • In the formula Ns = 60f ÷ P, what does P represent in the synchronous speed calculation?
  • What is the third listed advantage of AC motors over DC motors?
  • Impedance is measured in which unit?
  • Which statement describes the difference between thermal and magnetic circuit breakers?
  • A photocell is in which mode when its output is ON only if light from the source is detected?
  • What is the formula for X_L (inductive reactance)?
  • For the mechanical operations lifetime of an IEC contactor, what is commonly expected?
  • In a circuit with capacitors connected in series, how does the total capacitance compare to the individual capacitors?
  • In a Delta (Δ) configuration, how are line current and phase current related, and how are line voltage and phase voltage related?
  • Which of the following is the correct expression for slip (S) in terms of synchronous speed Ns and rotor speed Nr?
  • How is the shaft centerline height from the bottom of the feet determined from the frame size?
  • What is solenoid action?
  • Overload current is typically how many times the normal current?
  • White wires with blue stripes indicate which type of conductor?
  • Which statement correctly lists the available photocell configurations?
  • Which statement defines the continuous current rating?
  • In a wound rotor motor, which component provides the external connection to rotor windings?
  • In ambient-compensated circuit breaker, which element responds to current?
  • In the three-phase power equations, which statement correctly describes the use of the angle φ for real and reactive power?
  • What type of button will E-stops be?
  • What does S stand for in power calculations?
  • Which of the following is a unit of inductive reactance?
  • Which are uses of the Control Relay?
  • What are the two basic types of current-limiting fuses?
  • Where will all pushbuttons be installed relative to their associated stop buttons?
  • What is the DC power formula?
  • How is slip expressed as a percentage?
  • Which statement about current-limiting fuses is NOT true?
  • In a delta configuration, line current equals what multiple of phase current?
  • What are the two modes of operation for ultrasonic sensors?
  • Inductance L is defined as the coil's ability to oppose a change in current flow and is measured in henries. Which option describes inductance most accurately?
  • What type of surfaces are INDUCTIVE prox sensors able to detect?
  • Open Drip Proof (ODP) motor design permits air exchange around windings within which angle range downward from the vertical?
  • How do fuses operate?
  • Besides increasing the frequency, which would increase the inductive reactance X_L?
  • Which component is used to detect the light source in a photocell?
  • What is the formula to find Imax from Irms?
  • What is used to stop chattering in coils?
  • In AC motors, what is slip?
  • What is the purpose of a fuse?
  • Who are CSA and UL?
  • Which statement best describes how IEC contactor life expectations are specified?
  • What do GREEN wires with or without YELLOW stripes signify?
  • How overloads and shorts manifest in single-element and dual-element fuses?
  • Impedance Z is the total opposition to current flow in an AC circuit. It is the vector sum of resistance and reactance. Which statement best completes this definition?
  • What is the purpose of a transformer?
  • What is the correct unit for inductance?
  • What should you do when asked to state or draw all impedance triangles?
  • Which color wires signify equipment grounding conductors?
  • What is an Open Drip Proof (ODP) motor?
  • Which of the following is a heavy-duty AC push-button rating?
  • What is the fourth listed advantage of AC motors over DC motors?
  • Apparent Power (S) equals V × I and is measured in VA. Which option represents Apparent Power?
  • In AC motor efficiency, Pout represents what?
  • In distribution protection, selective coordination means only the protective device nearest the fault opens. Which term describes this behavior?
  • The coil that delivers energy to the AC load is called the
  • Who is most likely to be a feet guy?
  • What do WHITE wires signify?
  • Who has the best beard in the class?
  • What is a common problem with shielded capacitive proximity sensors?
  • Who is most likely to be forcibly removed from campus?
  • When detecting fluid levels through a tank, which type of proximity sensor would be used?
  • Three-phase circuits can be used for single-phase loads. True or false?
  • Stop buttons are what color and type?
  • Voltage Rating of a Fuse is defined as:
  • Which of the following is a heavy-duty DC push-button rating?
  • What do rectifier circuits do?
  • A _________________ belongs to both the control circuit and the power circuit.
  • What is the second listed advantage of AC motors over DC motors?
  • Which description best describes an E-stop button in safety systems?
  • What are the minimum conductor sizes for power and control circuits?
  • Which statement best describes AC voltage?
  • In a wound rotor motor, what is the function of brushes?
  • Which expression represents the instantaneous voltage according to the sinusoidal formula?
  • Who is best behaved?
  • What is the formula for the average voltage Vav as stated?
  • In a Wye (Y) configuration, how are line voltage and phase voltage related, and how are line current and phase current related?
  • Which part supports the shaft and houses the bearings in a motor?
  • Which component is the stationary winding that provides the rotating magnetic field in a squirrel cage motor?
  • Which motor type is described as Open Drip Proof?
  • What types of surfaces are CAPACITIVE prox sensors able to detect?
  • Which of the following is NOT listed as a use of the Control Relay?
  • Which statement is an advantage of circuit breakers over fuses?
  • Among short circuit current and overload current, which is typically greater?
  • Which formula defines the root-mean-square (Vrms) value in terms of Vmax?
  • In periodic wave terminology, what does T represent?
  • How many advantages are listed for AC motors over DC motors?
  • Which proximity sensor variant is best suited for detecting materials with low dielectric constant?
  • Which statement about diode forward voltage drops is correct?
  • Interrupting Rating refers to which characteristic?
  • What are the two requirements for a circuit?
  • Which of the following is a standard duty AC push-button rating?
  • Which component is the rotating member of a squirrel cage motor that provides the torque to do the mechanical work?
Subscribe

Get the latest from Passetra

You can unsubscribe at any time. Read our privacy policy